How to set up the intelligent temperature controller

temperature controller deviation adjustment: The adjustment of the displayed value can be terminated when it is determined that the value displayed by the dashboard is not the appropriate measurement value. Press and hold the SET button for three seconds to enter the instrument’s inner menu. The first parameter displayed and flashing is EO0, which represents the advance angle. Press the SET button repeatedly to cycle through the parameters; the one currently displayed and flashing is the offset adjustment parameter, which can be adjusted using the △ or ▽ buttons. The adjustment range of deviation is -8.8 ℃ to 8.8 ℃. Press SET button to withdraw after adjustment. Adjust the numerical 0.7 when the instrument panel is in the original factory, and prevent the appropriate instrument panel from being adjusted to the wrong one during application. It seems that the increase is complicated, but in fact the actual operation is very simple.

one thing to remind everyone is that when applying temperature control instrument , the method must be appropriate, because it also has a service life, if the application method is not appropriate, it will reduce its service life, so the problem of attention has to develop vigilance. Ultimately, I hope that the profound insights and information presented here will be of some individual benefit to everyone.

low limit partial alarm setting: press SET key to select and present SLP, emerald green display screen displays the standard value of this main parameter, and select move, increase and increment keys to set or adjust this main parameter. This primary parameter indicates the difference between the alarm point and the setting point of the mass-produced software. Limit partial alarm setting: press SET key to select and present SHP, emerald green display screen to display the standard value of this main parameter, select move, increase, increment key to set or adjust this main parameter. This main parameter indicates that the alarm point is higher than the distance value of the production software set point.

proportion category setting: press SET key to select and present p, emerald green display screen displays the standard value of this main parameter, and select move, increase and increment keys to set or adjust this main parameter. The larger the P value, the lower the convenience ratio of the output of the mass production software