Compressive strength instrument safety protection digital temperature controller detection function

safety maintenance of compressive strength meter professional thermostat equipment inspection function

tensile strength meter includes driver control circuit, simulation signal analysis and large space data storage function.

tensile strength meter can formulate larger precision measuring force according to customer satisfaction, and has intelligent system functions such as real-time display information of force value.

Analysis of the dashboard

The tensile strength meter has a professional thermostat that fully automatically clamps the core sample and is getting tighter.

The foot-operated safety protector is closely integrated with the hardware safety maintenance settings high-precision thermostat .

The driving force of the instrument and equipment is micro-motor driver and lithium power supply system, which is suitable for inspection under difficult environment. After charging, the battery can sustain at least 80 experimental cycles.

Configure safety belt and special instrument box, convenient belt.

Tensile strength meter is usually maintained

1. Each part of the tensile strength meter should be scrubbed and cleaned frequently. After scrubbing and cleaning the unsprayed surface, use pure cotton yarn to dip a small amount of car engine oil to wipe it again to avoid rust. During rainy periods, attention should be paid to scrubbing and dust cover to prevent dust invasion when not needed.

2. all valves on the control box of the tensile strength meter cannot be opened and placed to prevent dust from entering the inside and endangering the coordination of the accurate measurement organization.

3. long-term frequent application will cause the remaining oil to decrease or mildew. it should be checked every 1-3 months according to the application status. 15 minutes after the termination of the operation of the machine equipment, check the oil window on the left side of the control box gauge. If the oil level is smaller than that of the oil window, add the same gear oil to the middle part of the oil window. If the oil is moldy, replace the new gear oil.

4. regular application of tensile strength meter to Rashen breaking test will cause some standard parts to loosen.